Differences

This shows you the differences between two versions of the page.

--- documents [2021/12/15 16:26] – 142.97.53.160
+++ documents [2023/11/30 15:04] (current) – reno
@@ Line 1: / Line 1: @@
 ====== Documents ======
-===== SOP =====
+===== Environment and Climate Change Canada's Brewer's SOP =====
 {{ :docs:brewer_site_operators_manual_v2.2.pdf |Brewer Site Operators SOP}}\\
 {{ :docs:aersol_optical_depth_sop_v2.pdf|Aersol Optical Depth}}\\
@@ Line 10: / Line 10: @@
 {{ :docs:brewer_temp_coeff_generation_sop.pdf |Temp Cal}}
 ===== Manuals =====
+{{ :docs:brewer_mkii_operators_manual.pdf |Brewer MKII Operators Manual}}\\
 {{ :docs:brewer_mkiii_operators_manual_revd.pdf |Brewer MKIII Operators Manual}}\\
 {{ :docs:mkiii_service_manual_revd_sb.pdf |Brewer MKIII Service Manual}}\\
@@ Line 18: / Line 19: @@
 {{ :docs:instrument_setup.pdf | Brewer Instrument Installation}}\\
 {{ :docs:basic_maintenance.pdf | Basic Maintenance}}
-===== Historic Information =====
+===== Standard Work Procedures =====
-{{ :docs:data_cable_wiring.pdf | Data Cable Wiring}}\\
 {{ :docs:tracker_upgrade_refurbishment.pdf | Tracker Rotary Connector Upgrade & Refurbishment}}\\
+{{ :docs:no2_micro_offset_value.pdf | NO2 Micrometer Setup}}\\
+{{ :docs:finding_micrometer.pdf | Initial Determination of the Micrometer Reference}}\\
+{{ :docs:finding_a_dispersion_from_scratch.pdf | Manual Dispersion Calculation of a Brewer}}\\
+===== Other Useful Pages =====
+[[linux|Linux - Additional Tricks and Tips]]\\
+[[firmware|MKIII Brewer Firmware Update instructions]]
+===== Historic Information =====
+{{ :docs:micrometer_optical_led_reference_triggering.pdf | Brewer Micrometer Optical LED Triggering}}\\
 {{ :docs:tracker_wire_diagram.pdf | Tracker Wire Diagram}}\\
 {{ :docs:brewer_calculation_rh_temp.pdf | Brewer Calculation of RH and Temp}}\\
+{{ :docs:modifying_the_zero_position.pdf | Modifying the zero position of a Brewer}}\\
 {{ :docs:nv175_pinouts.pdf | TDK Lambda NV175 Pinouts}}\\
 {{ :docs:nv175_sb.pdf | TDK Lambda NV175 Single board config}}\\
@@ Line 28: / Line 39: @@
 {{ :docs:ios_microboard_jumpers.pdf | IOS Microprocessor Board Jumper Settings}}\\
 {{ :docs:ios_multi_io_board.pdf | IOS Multi Configuration I/O Board Jumper Table}}\\
-{{ :docs:firmware_config_upload.pdf | Brewer Firmware and Configuration Update Procedures}}\\
+{{ :docs:data_cable_wiring.pdf | Data Cable Wiring}}\\
-{{ :docs:no2_micro_offset_value.pdf | NO2 Micrometer Setup}}\\
+{{ :docs:shutter_cct_setup_multiboard_elec.pdf | Shutter Motor Setup}}\\