skc
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| skc [2021/11/25 03:14] – mbrohart | skc [2024/01/30 13:10] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| SKC allows an operating schedule, manually created or by the SE command, to be run continuously - that is, at the end of the local day a set of summary records is produced (see [[ed|ED]]), and the schedule waits for the beginning of the next day and the schedule starts again. \\ | SKC allows an operating schedule, manually created or by the SE command, to be run continuously - that is, at the end of the local day a set of summary records is produced (see [[ed|ED]]), and the schedule waits for the beginning of the next day and the schedule starts again. \\ | ||
| + | When SKC is ran, it will create a copy of the OP_ST.### to OP_ST.000 as backup as of version 6.2\\ | ||
| + | That OP_ST.000 will then be copied in to the OP_ST.### in during an [[re|RE]] in case of corruption. | ||
| - | See also Section 8 of the Brewer Operators Manual, and the SE and SK commands. | + | See also Section 8 of the Brewer Operators Manual, |
| Line 12: | Line 14: | ||
| ===== List of schedule used by ECCC ==== | ===== List of schedule used by ECCC ==== | ||
| - | * calsc | ||
| * CAL | * CAL | ||
| + | * calo3 | ||
| + | * calsc | ||
| * calzs | * calzs | ||
| + | * clscnouv | ||
| + | * ecdiag | ||
| + | * eceo | ||
| * eceu | * eceu | ||
| * ecnouv | * ecnouv | ||
| * ecsc | * ecsc | ||
| * idle | * idle | ||
| - | * mb | + | * inside |
| * s60mk2 | * s60mk2 | ||
| + | * s60mk2nv | ||
| * s60mk3 | * s60mk3 | ||
| * spmoon | * spmoon | ||
skc.1637810058.txt.gz · Last modified: 2021/11/25 03:14 by mbrohart