====== Installation for New Style Desiccant Holder ======

===== Old electronics (Multi-board) =====

  - Take the lid off the brewer
  - Turn off the brewer
  - Remove the tub of desiccant 
  - Remove the 3 holding down the case on the secondary power supply as shown below {{:pictures:desiccant:20201209_111601b.jpg?600|}}
  - Remove the secondary power supply cover and replace it with one that has the desiccant holder pre-installed.{{:pictures:desiccant:20201209_111756.jpg?600|}}
  - Place a fresh can of desiccant into the holder\\ {{:pictures:desiccant:20201209_111803.jpg?600|}}

===== New Electronics (Single-board)=====

  - Place the new desiccant holder as shown in the picture below.\\ {{:pictures:desiccant:microsoftteams-image_2_.jpg?600|}}
  - Secure the holder in place with the supplied crossbeam.\\ {{:pictures:desiccant:microsoftteams-image_3_.jpg?400|}}
  - Place a fresh can of desiccant into the holder. \\ {{:pictures:desiccant:microsoftteams-image_5_.jpg?400|}}