Table of Contents

Installation for New Style Desiccant Holder

Old electronics (Multi-board)

  1. Take the lid off the brewer
  2. Turn off the brewer
  3. Remove the tub of desiccant
  4. Remove the 3 holding down the case on the secondary power supply as shown below
  5. Remove the secondary power supply cover and replace it with one that has the desiccant holder pre-installed.
  6. Place a fresh can of desiccant into the holder

New Electronics (Single-board)

  1. Place the new desiccant holder as shown in the picture below.
  2. Secure the holder in place with the supplied crossbeam.
  3. Place a fresh can of desiccant into the holder.