Everything you need to know about shutters!
Differences in the shutter control between singleboard electronics and multiboard electronics
| Singleboard Electronics | Multiboard Electronics | |
|---|---|---|
| Shutter delay | Typically the default is left at 14. This changings the speed of the shutter | Usually the default is around 80. |
| Adjusting for slit mask position | To change position where the slit stops, the slitmask hard stop needs to be adjusted. | There is a holding current on each position, if the slit mask doesn't stop in the correct location, the motor can be rotated slightly to adjust the slit mask positioning. If the position is far off, the slit mask will need to be rotated on the motor shaft |