This is an old revision of the document!
Table of Contents
Single Board Electronics
The single board electronics, sometimes referred to new electronics are usually used in the MKIII Brewers. There's a very small numbers of MKIV brewers that may run a single board electronics. The single board electronics consist of the primary power supply¹ (PPS), lamp control board and the high voltage module. There are two version of the single board electronics, V1 and V2. See here for firmware programing instructions.
¹Note, both multiboard and single board electronics both have an PPS, however the multiboard uses a 24V/15V/5V power supply while the single board electronics uses 24V/12V/5V power supply. The latest brewer's produced by Kip and Zonen (around Brewer # 250) uses the TDK-Lambda NV175 series power supply. The single Electronics board uses NV1-4G5TT, where the multiboard uses the NV14G5FF.
Mainboard Flat Cable Connections
| Cable | Name | Useage |
|---|---|---|
| J2 Top | BA-W77/A | Lamp Board |
| J2 Bottom | BA-W77/B | J1 on hv module |
| J13 Top | BA-W76/B | Iris |
| J13 Bottom | BA-W76/A | Zenith |
| J14 Top | BA-W76/B | Filter wheel #1 |
| J14 Bottom | BA-W76/B | Filter wheel #2 |
| J15 Top | BA-W76/A | Micrometer #2 (MKIII only) |
| J15 Bottom | BA-W76/A | Micrometer #1 |
| J16 Bottom | BA-W76/C | Filter wheel#3 (MK IV only} |
| J17 Top | BA-W76/B | Slitmask (shutter) |
| J17 Bottom | BA-W76/A | Azimuth |
| J12 Top | BA-W76/A | Control switch’s |
| J7 Top | Communication | |
| J7 Bottom | Humidity sensor |
SL/HG adjustments
| SL Voltage | HG Voltage | SL Current |
Commands
Frequently used commands in MM/TT
| Command | description |
|---|---|
| I,X | Resets motor X |
| ?motor.ref.high[X] | checks the reference flag of motor X on the high side |
| ?motor.ref.low[X] | checks the reference flag of motor X on the low side |
| ?motor.address.[MOTOR] | checks the motor address used for MOTOR |