SKC allows an operating schedule, created by the SE command, to be run continuously - that is, at the end of the local day a set of summary records is produced (see ED), and the schedule waits for the beginning of the next day and the schedule starts again. See also Section 8, and the SE and SK commands.

This routine name stands for schedule, continuous mode. The command is used to input the desired schedule to be used by the instrument for the day.
The schedule is then continuous in that it is restarted the following days.

Once SKC is ran, dosbox will bring you to a new screen where you can type in the name of the new schedule I.E.: ecsc

• calsc
• CAL
• calzs
• eceu
• ecnouv
• ecsc
• idle
• mb
• s60mk2
• s60mk3
• spmoon
• spsun
• to1mk2um
• to2mk2um
• to3mk2um
• to4mk2um