desiccant_can
This is an old revision of the document!
Table of Contents
Installation for New Style Desiccant Holder
Old electronics (Multi-board)
- Take the lid off the brewer
- Turn off the brewer
- Remove the tub of desiccant
- Remove the 3 holding down the case on the secondary power supply as shown below
- Remove the secondary power supply cover and replace it with one that has the desiccant holder pre-installed.
- Place a fresh can of desiccant into the holder\\
New Electronics (Single-board)
- Place the new desiccant holder as shown in the picture below.
- Secure the holder in place with the supplied crossbeam.
- place a fresh can of desiccant into the holder.
desiccant_can.1607538341.txt.gz · Last modified: 2020/12/09 18:25 by reno