This is an old revision of the document!
Table of Contents
FAQ
Lamps
Q: What do you have to consider after a Standard Lamp bulb change?
A: Ensure brightest part of the band of light is sitting in the middle of the Iris. There are two ways to accomplish this.
Micrometers
Q: How do I find the micrometer offsets if I don't know where the HG emission lines are??
A: Finding Micrometer Offsets from Scratch
Q: What should a grating scan look like when ploted?
A: Troubleshooting Grating Scans
GVIM
Q: To remove the ^M
A: Type: :%s/^M/ /g
(note to type in ^M Ctrl+V Ctrl+M)
Old Electronics
Q: What is the differences between new vs old temperature circuit on the clock board?
A: Note the resistors on the top left of the boards below (New Vs Old). New temperature circuits, some resistors has been replaced with a jumper wire.
