Q: What do you have to consider after a Standard Lamp bulb change?
A: Ensure brightest part of the band of light is sitting in the middle of the Iris. There are two ways to accomplish this.

More...

Q: How do I find the micrometer offsets if I don't know where the HG emission lines are??
A: Finding Micrometer Offsets from Scratch

Q: What should a grating scan look like when plotted?
A: Troubleshooting Grating Scans

Q: To remove the ^M
A: Type: :%s/^M/ /g
(note to type in ^M Ctrl+V Ctrl+M)

Q: What is the differences between new vs old temperature circuit on the clock board? A: Note the resistors on the top left of the boards below (New Vs Old). New temperature circuits, some resistors has been replaced with a jumper wire.

Q: How do you disable the az check at the start of a the schedule?
A: Inside the skc.rtn, in line 18, add the instrument number you would like the instrument to ignore. Note: You may need to add it into the master program directory or disable the instrument from getting its program updated daily.

Q: How do I remote into ___ site?
A: You can connect to most site with sshvncNote: You must login to your @ec.gc.ca email and use a compatible browser to access the files. |
Note: SPO requires a few extra steps, see SPO