Everything about micrometers!

To check to see if the micrometer can move from one end to the next, you move the micrometer by (Cal Step) + (Zero position).
Examples: If (Cal Step)+(Zero Position) = x

dosbox

>M,10,-x
 - This will move the micrometer towards the mirror
>M,10,x+1
>M,10,-1
 - Type the absolute value for the movements (x-1, ie x=2121 --> 2121 +1 = 2122)
 - This will move the micrometer back to the measuring position, the -1 will reset the zero location

To move the micrometer to the bulkhead position, find the highest step number in either the UV or a CJ file, let that number by y. starting from your zero position, run the following

dosbox

>M,10,y

Refer to Motor Positions for the motor numbers

Micrometer Optical LED Reference Trigger
Finding the Micrometer
micrometer_optical_led_reference_triggering.pdf - Includes the Schmitt Trigger schematics.